Introduction For Installation Of LED Line Lights

Nov 14,2019 13 views
The led line lamp housing is made of aluminum alloy, with clear lines, simple structure, beautiful appearance, firmness, corrosion resistance and easy installation. For the installation of led line lights is also very particular, so today we will specifically understand the installation method of led line lights. LED Line Light Installation Method

Idoor installation of LED Line Lights

When the led line light is used for interior decoration the installation is very simple. The back of each of our wholesale led line lights is affixed with self-adhesive 3M double-sided adhesive. When installing, you can directly remove the 3M double-side dad he sive surface sticker. Then fix the light bar in the place where it needs to be in stalled, and flatten it by hand. The led line lamp is a circuit structure consisting of three LED lamp beads in a series-parallel manner. Each of the three LED lamp beads can be cut and used separately. How long it needs to be used, it can be cut off, but it is necessary to pay attention to the pad.    

Outdoor installation of LED Line Lights

The outdoor installation of led line lights pays more attention to the waterproofing and installation of the light strips. The reason why the led line lamp is installed in this way is mainly because the led line lamp will withstand the wind and rain. If the 3M glue is used for fixing, the 3M adhesive will be reduced for a long time and the led line light will fall off. Therefore, the outdoor installation often adopts the card slot. The fixed way, where you need to cut and connect, the method is the same as the indoor installation, just need to be equipped with waterproof glue to consolidate the waterproof effect of the joint. Then use a special fixed clip to fix, you can use electric hammer to open the eye or use plastic expansion tube and screw to fix the clip.    

Wiring method

  The general voltage of led line lamp is AC220V, DC12V, DC24V. Therefore, it is necessary to select a suitable switching power supply. The size of the power supply is determined according to the power and connection length of the LED light bar. It should be noted that DC12V and DC24V should not be connected to AC220V, otherwise the lamp beads will burn out. DC12V can not be connected to the DC24V control power supply; otherwise, the power will be more than doubled, and it is easy to burn out the lamp bead. AC220V lights can be directly connected to the mains. RGB colorful LED strips need to use the controller to achieve the changing effect, generally using 4 lines to distinguish between black, red, green and blue. The colorful light bars are generally common anodes, that is, one of the light bars is +12V connected to the black line, the other is the negative pole, and the RGB is connected to the corresponding red, green and blue interface or power line.    

Connection distance

  In general, the 3528 series of LED line lights, the connection distance of up to 20 meters, 5050 series of LED lights, the longest connection distance is 15 meters. If this connection distance is exceeded, the led line lamp is very prone to heat, which will affect the service life of the led line lamp during use. The RGB simple controller has a control range of 10 to 15 meters, and the remote controller has a control range of 15 to 20 meters and a maximum distance of 30 meters. If the connection distance of the led line light is long and the controller cannot control the long light strip, then a power amplifier is needed for the tapping. Therefore, it must be installed according to the manufacturer's requirements when installing.

Follow Us